Home > Products > WiFi Router > DT-R3000
WiFi Router

DT-R3000

DT-R3000 is a high-performance wireless WIFI 6 Gigabit dual-band router with 4 Gigabit Ethernet ports (1 WAN port, 3 LAN ports) and supports 2.4G and 5G dual-band WIFI. It features a strong signal penetration, wide signal coverage, multi-device transceiver technology, low latency, and multi-device simultaneous connection ability.

DT-R3000 functions:

• Supports 2.4G and 5G dual-band WIFI6 with omnidirectional high-gain antennas;

• Features stronger signal penetration and wider signal coverage ability;

• The transmission process is more stable and the power consumption of wireless devices is reduced to meet with the requirements of wireless data transmission;

• Supports MESH/WPS;Supports IPv4 & IPv6;

• Supports wired networking and wireless networking to increase WIFI coverage;

• Supports automatic roaming function.

DT-R3000 specification
Power adaptor Input:100~240V AC/50-60HZ
Output:DC12V/1A
Size 224mmx158mmx30mm
Operating environment Operating temperature:-5~45℃
Operating humidity:5~95%(Non-condensing)
Protocol Standard PPPoE,DHCPv4,DHCPv6
WAN Interface CPU:ZX279128R + MT7976 + MT7916
SDRAM:2Gbit (128MBx16) DDR3 RAM + 1Gbit NAND Flash
NAND Flash
Interface:power x1, WAN x 1, LAN x 3
Antenna:5dBi high-gain omnidirectional antennas x4
LED ( Red / Green / Blue ):x 1
WIFI speed 2.4G WIFI:2*2 (speed 573Mbps)
5G WIFI:2*2 (speed 2402Mbps)
Frequency range 2.4G WIFI frequency: 2.4GHz~2.4835GHz
5G WIFI frequency: 5.150GHz~5.85GHz
Software functions Network mode:IPv4: static IP /dynamic IP /wired bridging/wireless bridging;
IPv6:dynamic IP
Mesh:802.11k/v Ethernet/WIFI intelligent networking seamless roaming
Wireless: supports channel selection, signal strength selection, wireless mode selection, bandwidth selection/WPS
Network security firewall: IP filtering/URL filtering/port filtering to prevent SYN flood attack and ping from WAN port
Time synchronization: time zone selection/NTP
Device management:supports password modification, router reboot, factory reset, firmware upgrade, etc.
Power consumption <10W